Brenton EPS400 Foiled Overlay Underfloor Heating Kit – 2 Zones, 150mm Centres

Plan a 2-zone wet underfloor heating installation with the Brenton eps400 foiled overlay kit, specified for 16mm pipe at 150mm centres. This package brings together the floor-system components, manifold, pump/blending pack and heating controls listed below. Two heating zones allow two areas to be planned around separate temperature schedules. Decide which rooms share each zone before selecting the area package, and have the installer confirm the control wiring and loop allocation. Select the area option that matches your project, then confirm the component quantities and floor construction before ordering.

Listed kit components

• 16mm aluminium-core multilayer pipe
• Brenton manifold with pipe fittings
• Grundfos pump/water-temperature control pack with Brenton blending valve
• Brenton 22mm 2-port zone valve
• 20mm EPS400 foil-faced boards for 16mm pipe at 150mm centres
• Heatmiser Slimline programmable room thermostat

These are the component types in the package description. Quantities and the final bill of materials depend on the selected area option; confirm them before ordering.

Key features

• 20mm EPS400 foil-faced overlay boards
• 150mm pipe centres with 16mm multilayer pipe
• Board-based pipe layout for a planned overlay installation
• Brenton manifold and Grundfos pump/blending components listed

Specifications

Choosing and using this product

EPS400 foil-faced panels provide the routed pipe layer for this overlay system. The 20mm dimension refers to the board, so adhesives, levelling layers and the floor finish must be included when checking the complete floor build-up. Two heating zones allow two areas to be planned around separate temperature schedules. Decide which rooms share each zone before selecting the area package, and have the installer confirm the control wiring and loop allocation.

Planning the controls and any extras

• View Heatmiser Slimline thermostat specifications
• Review Heatmiser UH8 wiring-centre specifications

Check component compatibility against your system specification before ordering.

Frequently asked questions

What does the 2-zone designation mean?

Two heating zones allow two areas to be planned around separate temperature schedules. Decide which rooms share each zone before selecting the area package, and have the installer confirm the control wiring and loop allocation.

Is the finished floor only 20mm higher?

20mm is the board thickness. Adhesive, preparation, load-spreading or levelling layers and the final floor covering can add height. Confirm the full approved build-up for your chosen finish.

Does the kit area guarantee it will heat my property?

No. The area option identifies the package choice. Suitability and heat output require a room-by-room heat-loss calculation, the intended flow temperature and the proposed floor construction.

What should I confirm before ordering?

Ask for the exact bill of materials for the chosen area: pipe length, manifold ports, thermostat quantities, actuators and wiring centre requirements. Confirm any insulation, adhesives and floor-finish layers separately.

Need help with your product choice? Call 0116 319 6618. For a complete underfloor heating project, send your floor plans for a quotation. Check delivery information before ordering.